Technical reference · TC · TG4 · EC
Oil Seal Engineering Guide: Compounds, Tolerances & Installation
Compound data for Black NBR and Brown FKM, lip interference values, and recommended shaft and housing bore machining for Type TC, TG4 and EC seals.
Production Elastomers
Two Standardized Compounds Across TC, TG4 & EC
DTO standardizes exclusively on verified Black NBR and Brown FKM formulations to ensure consistent batch cure curves, shore hardness, and thermal stability.
| Compound & Color | Standard Classification | Hardness | Operating Temp Range | Compatible Media & Typical Equipment |
|---|---|---|---|---|
| Black NBR (Nitrile) | ASTM D1418 / ISO 1629 NBR | 70 ± 5 Shore A | -40°C to +120°C | Mineral oils, hydraulic oils, lubricating greases, water; standard motors, pumps & gear reducers |
| Brown FKM (Fluoroelastomer) | ASTM D1418 / ISO 1629 FKM (FPM) | 75 ± 5 Shore A | -20°C to +200°C | Synthetic gear oils (PAG / PAO), extreme-pressure additives, fuels; continuous high-temp gearboxes & drives |
Standard Hardware Reference
Shaft & Housing Bore Machining Guidelines
Reference installation parameters aligned with ISO 6194-1 and DIN 3760 rotary seal standards:
- Housing Bore ToleranceISO H8
- Housing Bore RoughnessRa 1.6 – 6.3 μm (Rubber-Covered OD)
- Shaft Diameter ToleranceISO h11
- Shaft Surface Hardness≥ 55 HRC Recommended
- Shaft Plunge-Ground FinishRa 0.2 – 0.8 μm (Lead-Free)
- Installation Lead-In Chamfer15° – 30° Deburred Chamfer
DTO Factory Process Control
Lip Interference & Structural Comparison
Controlled internal molding dimensions across our three core product series:
- 30 – 60 mm Shaft Primary Lip Interference0.40 mm Nominal (0.20–0.50 mm Range)
- Example (TC 32×47×7 mm)Molded Lip ID 31.6 mm (31.5–31.8 mm)
- Type TC ArchitectureSmooth OD · Double Lip (2 Lips) + Spring
- Type TG4 ArchitectureCorrugated OD · Triple Lip (3 Lips) + Spring
- Type EC ArchitectureSmooth or Corrugated OD · Stamped SPCC Steel Cup